Teramix
SCOPE OF APPLICATION
It is used with a suitable primer as a coating material on the exterior of all kinds of buildings, on black plaster, exposed concrete, cement board and thermal insulation systems.
FEATURES
– It is produced in 2mm size.
– Since it is more elastic compared to cement-based products, it acts as a bridge in the cracks on the application surface.
– It is not affected by cracks that may occur as a result of the settlement of buildings.
– Thanks to its water vapor permeability, it allows water vapor to be expelled and the surface to breathe.
– It covers the surface defects due to the thick film layer it forms during application.
– It is not affected by external factors, weather conditions such as rain, snow, humidity, extreme heat or extreme cold, and its colors do not fade.
– It is resistant to UV and alkali.
– It is a water-based product.
-Does not smell, does not harm human health and the environment
APPLICATION VIDEO
After thoroughly removing any dirt, grease, blistered paint, and dust from the application surface, proceed to rectify surface defects using San Deco Acrylic Putty Interior, followed by an application of San Deco Decoprimer as an undercoat.
-For the first coat, apply Atracto a steel trowel or brush.
-The second coat can also be applied with a trowel or brush, allowing you to achieve the desired effect.
-Allow a minimum of 6 hours between each coat for proper drying. -Ensure that the application environment remains within the temperature range of +5°C to +35°C during and within the 24 hours following the application.
Allow a period of 2-3 hours for the paint to become touch dry, and a full 24 hours for it to completely dry under standard environmental conditions at 23°C.
The coverage of the paint depends on factors such as surface smoothness, porosity, and the chosen application methods for a single coat:
For Atracto:
- 1 liter covers an area ranging from 8.0 to 12.5 m².
- 1 kilogram covers an area spanning from 6.5 to 10.0 m².
- The paint consumption per 1m² area varies between 80-125 milliliters (ml) and 100-150 grams (gr).
For Atracto Touch:
- 1 liter provides coverage for an area between 8.5 and 13 m².
- 1 kilogram is sufficient for an area of 7 to 11 m².
- The paint consumption for 1m² area falls within the range of 76-118 milliliters (ml) and 90-140 grams (gr).
