Concrete Contract
SCOPE OF APPLICATION
It is used to increase the adherence of gypsum plaster and similar gypsum-lime mortars to exposed concrete.
FEATURES
– It adheres to the surface very well.
– It penetrates very well onto exposed concrete and prepares a good basis for other materials to be applied.
– It is a water-based product.
– It does not smell and does not harm human health and the environment.
APPLICATION VIDEO
After thoroughly removing any dirt, grease, blistered paint, and dust from the application surface, proceed to rectify surface defects using San Deco Acrylic Putty Interior, followed by an application of San Deco Decoprimer as an undercoat.
-For the first coat, apply Atracto a steel trowel or brush.
-The second coat can also be applied with a trowel or brush, allowing you to achieve the desired effect.
-Allow a minimum of 6 hours between each coat for proper drying. -Ensure that the application environment remains within the temperature range of +5°C to +35°C during and within the 24 hours following the application.
Allow a period of 2-3 hours for the paint to become touch dry, and a full 24 hours for it to completely dry under standard environmental conditions at 23°C.
The coverage of the paint depends on factors such as surface smoothness, porosity, and the chosen application methods for a single coat:
For Atracto:
- 1 liter covers an area ranging from 8.0 to 12.5 m².
- 1 kilogram covers an area spanning from 6.5 to 10.0 m².
- The paint consumption per 1m² area varies between 80-125 milliliters (ml) and 100-150 grams (gr).
For Atracto Touch:
- 1 liter provides coverage for an area between 8.5 and 13 m².
- 1 kilogram is sufficient for an area of 7 to 11 m².
- The paint consumption for 1m² area falls within the range of 76-118 milliliters (ml) and 90-140 grams (gr).
